CGSB has been reviewing its CAN/CGSB 44.232 – Canadian General Standards Board – Chairs for Office Environments. The ballot officially closes today! We, Micom laboratories are voting YES to this standard’s revision. The proposed standard now allows for self-counter balancing mechanisms that could qualify to the previous standard’s version. From a mechanical testing standpoint CAN/CGSB 44.232 still calls up BIFMA X 5.1 whereas for measurements it still calls up BIFMA cmd-1
In as much as we were adamant about not allowing the previous draft version to be voted in because we thought it was significantly flawed, we think the current version is good despite the fact that it brings its lot of surprises. Indeed, side chairs, for example, were historically left out of the standard. Public Works was, and is still, using its “Product Description #6” (PD-6) for side chairs. Side chairs are now imbedded in the 44.232 standard and this brings a complete array of new dimensional criteria, using the chair measuring device for measuring them. Will this be a Pandora box? Time will tell, we believe this might very well be the case.
There are also changes impacting the more traditional types of chairs that used to be covered by CAN/CGSB 44.232; this category now falls under either “Computer Use Chairs” and “Conference Room Chairs”. The first one that comes to mind is the seat height range for regular seat height. Historically the mandatory range for regular seat height was 419 mm to 510 mm. It has now been expanded to 417 mm to 512 mm. This may seem like a very minor change, however we have seen many manufacturers struggling with this requirement. The extra 4 mm will be a tough one for many.
Micom is a third party industrial laboratory accredited by the Standards Council of Canada, CGSB, ISTA and many other organizations.
COMPARAISON BETWEEN CGSB-44.232 Ballot Aug. 2017 AND CGSB-44.232.2008
Note: only sections where there are technical changes are inluded in this comparison